1 Channel Relay with Opto

Add to Quote
Compare
SKU: PPA13 Category:

This is 1 Channel 5V Relay Board Module For Arduino PIC AVR DSP ARM. A wide range of microcontrollers such as Arduino, AVR, PIC, ARM and so on can control it.

Each one needs 15mA – 20mA driver current and Equipped with high current relay: DC 5V / 10A, AC 250V / 10A

Standard interface that can be compatible with microcontroller.

Specification and Features :-

  • 1 channel relay board
  • Operating Voltage 5V
  • Max Current : 20mA
  • Relay Contact Current Capacity at AC250V: 10A
  • Relay Contact Current Capacity at DC5V: 10A
  • One normally closed contact and one normally open contact
  • Triode drive, increasing relay coil
  • High impedance controller pin
  • Pull-down circuit for avoidance of malfunction
  • Power supply indicator lamp
  • Control indicator lamp
  • Indicator for Relay output status
  • Can Be controlled various appliances & other Equipment With Large current.
  • Standard TTL Level logic controlled (AVR, Arduino, 8051, PIC, ARM)
  • The module is compliant with international safety standards, control and load areas isolation trenches;

Reviews

There are no reviews yet.

Be the first to review “1 Channel Relay with Opto”

Your email address will not be published. Required fields are marked *